Our electric range is on its last legs. We have rebuilt the cassettes, replaced circuit boards etc. Not only does the electronics randomly fritz out but parts are starting to become not available. We have been talking about replacing it because it has been loved to death.

There are two issues, it is a downdraft and therefore needs to be replaced with another of the same style (or completely remodel the kitchen) and it is built into the cabinets, so measurements are important. With that, we have been dragging our feet because it is going to be an expensive proposition.

The two eight inch burners (the big ones) have become very spotty lately. Both of them are crap shoots as to whether they will work this time or not. Sometimes, I will spend five minutes jiggling the burner until it finally works. They also sometimes cut out while cooking, this is very difficult to deal with because everything is hot for so long afterward.

I decided to order some generic replacement coils because we needed our range to prepare Easter dinner and I was tired of gambling. It turns out that this was also a gamble because the coils did not fit into the stove. I didn’t have time to return them and see if I could find something else, I went to modifying the setup so that it works.

While this was nearly an exact match of the old one, there were a couple of differences. One, the tabs where the burner plugged in was about a quarter of an inch longer than the last one. This pushed the support structure too far out. I decided to cut the support structure rather than the plug in ends. This I did with a hacksaw. I also had to grind the notch deeper after I cut off the excess.

That burner fit. The second one, I also had to cut off a quarter of an inch off the plugs. Before I did all that work, I plugged them in to make sure they work, which they did. Otherwise, I would have had to return them before modification. Now I have working burners again.

This was less than ideal. Obviously, I didn’t want to spend a hour modifying these burners when they were supposed to fit in the first place. However, I was tired of the old ones stopping while I was trying to use them. Was it worth the effort, probably. Was it worth the cost savings, probably not. An hour of my time more than paid for the difference between generics vs Whirlpool/Jenn air burners.

End Your Programming Routine: People forget that there is also a cost in returning items. For me, the return point is almost half an hour away. I am generally an OEM guy for these reasons, it is cheaper in the long run. My logic was that I didn’t want to invest in something that was going away. But, what is the cost of not being able to cook? Certainly a few meals out would recover that anyway.